To Unset System
|
Either scroll down the whole guide or use navigation area below to jump to specific operations. |
|
|
Setting/Unsetting. After an Activation. Part Setting. Omitting Zones Changing Codes Chime |
| With the system off the display will show: | |
| Enter your four digit code | |
| After short pause the exit tone will start. Leave via the designated route. | |
| Close the door, the exit tone will change from intermittent to continuous and will stop after approximately 10 seconds | |
|
To Unset System
|
|
| Enter premises via designated entry route | |
| Enter your four digit code | |
| One of the zone LED's will be flashing. |  |
| The number of the LED indicates the number of the zone that caused the activation. | |
| If you know the reason for the activation, user error, insecure door or window etc. enter your code once more to reset. | |
| If you do not know why the alarm has been activated you will need to call engineer. We can then ensure your system is functioning correctly. | |
|
If the flashing LED is accompanied by a fault LED from the second row then there is another type of fault. Here is a description of each type although most will require a visit from an engineer to rectify. |
Circuit Tamper
External Sounder Tamper Fault
Control Panel Tamper |
| Enter your four digit code and press X | |
| The 1 & 2 LED's will flash. If you press nothing the system will full set. |  |
| Press either the 1 or 2 key to enable the required part set. If you are unsure which detectors are ommited during part sets an engineer will be able to help during a routine inspection, special visit or telephone call. |  |
| When the exit time has elapsed the tone will stop or a confirmation tone will be heard. |  |
| Enter your four digit code to unset the system. | |
| Enter a master or main access code | |
| Press X |  |
| Press X |  |
| Press the keys relating to the zones you wish to omit. When LED's for all zones you wish to omit are flashing wait for the exit tone to start and leave via exit route. Or press the Tick to enable silent setting. |  |
|
Ommiting 24hr Zones
|
|
| Enter a master or main access code | |
| Press X | |
| Press X | |
| Press the keys relating to the zones you wish to omit. When LED's for all zones you wish to omit are flashing press 0/esc to return to day mode, you have 10 seconds to perform this operation. |
|
| To re-enable zones enter code. | |
| When the exit tone starts re-enter the code and system will return to day mode with all zones active | |
| Press 1 X (existing master code) X | |
| You now have 10 seconds to type in the new code, as you do so the four LED's on the top row will extinguish with each button press. |
|
| Upon entering the fourth digit the LED's will re light enter the new code again to verify. The panel will beep during this procedure. |
|
| Hold keys 1&3 until top row of LED's illuminate. |  |
| Press key corresponding to zone you wish to chime. eg 1 |  |
| When all required zones are flashing leave panel and it will return to day mode |  |
| Repeat process in reverse to turn off. | |
